this weeken i setup a wireless network in a large house and everything is working perfectly. the only complaint i received was that hte external led light is very bright when it gets dark (as it is located in one of the bedrooms this is a bit of an issue)
i found the following command
AP1(config)#led display ?
dim Turn LED display dim.
off Turn LED display off.
AP1(config)#led display off
i applied the above command but i have no way of veryfing (as i am not on site) if the external led has now turned off.
i could not find a command to show me the current led status (on/off/dim)
so 2 questions
1) will this command have turned off the external LED
2) how can you verify via the command line what the current status is