• Advertisement

Setup FXS port for use with analog phone

Cisco CallManager, Cisco CallManager Express and IP Video

Setup FXS port for use with analog phone

Postby AlistairCarr » Mon Jun 03, 2013 7:03 am

Hi, I'm trying configure a very basic FXS port for use with an analogue phone

config on for the dial peer is as follows

dial-peer voice 30 pots
destination-pattern 276
port 0/1/0


fxs port configuration is below

voice-port 0/1/0
trunk-group 1
description Walkabout Phone

If i connect an analog phone to the port none of the LED's on the FXS light up,

If i call 276 from an ip handset the handset does not ring however i get the ringing tone in the phone that im using to try and call the analog handset.

If I shutdown the port and then try to call 276 from an IP handset again i get the number doesn't exist tone (I think it is)

I think the config is correct on the CME (2811 )

Stuck as to whats going on ?

Thanks in advance,
AlistairCarr
Hello I'm new here
 
Posts: 1
Joined: Mon Jun 03, 2013 6:46 am

Advertisement


  • Advertisement


Similar topics


Return to Cisco IP Communications

Who is online

Users browsing this forum: No registered users and 4 guests