Hi, I'm trying configure a very basic FXS port for use with an analogue phone
config on for the dial peer is as follows
dial-peer voice 30 pots
fxs port configuration is below
description Walkabout Phone
If i connect an analog phone to the port none of the LED's on the FXS light up,
If i call 276 from an ip handset the handset does not ring however i get the ringing tone in the phone that im using to try and call the analog handset.
If I shutdown the port and then try to call 276 from an IP handset again i get the number doesn't exist tone (I think it is)
I think the config is correct on the CME (2811 )
Stuck as to whats going on ?
Thanks in advance,