ASA 7.2(2) and snmp
ASA 7.2(2) and snmp
Hi all, I just put 7.2(2) software on a ASA 5540. I have some snmp servers on the outside interface. When I configure these server there is no problem, but then I can't save configuration because i get an error:1# wr memBuilding configuration...Cryptochecksum: xxx%Error reading system:/running-config (Configuration line too long)Error executing command[FAILED]Is this a bug or did syntax change?
Re:ASA 7.2(2) and snmp
How big/long your ASA configuration? The error message in bracket "Configuration line too long" may be a clue for the error.Try to remove the newly added lines, or any less important parameres, save it and see if you get the same error again.HTHAK
Re:ASA 7.2(2) and snmp
It's not a configuration lenght problem, adding or removing other lines has no effect.It's just with "snmp-server Outside ...."Thank you anyway
Re:ASA 7.2(2) and snmp
It is a bug. Configure max 3 snmp servers, or max 6 snmp servers, it depends on soft version.
Re:ASA 7.2(2) and snmp
I ran into the same problem on our ASA5520 on v7.2(2). We had 7 snmp servers on our pix515e's on 6.35 that we replaced with the ASA's. We had to pair our snmp server list down to only 3
