• Advertisement

How to Configure the Traffic Statistics Function on S2700?

MIBS, SMMPv1, SMMPv2, SMMPv3 and management

How to Configure the Traffic Statistics Function on S2700?

Postby hone » Sun Nov 20, 2016 7:43 pm

Assume that the statistics on ping packets from 10.1.1.0/24 need to be collected on the interface Ethernet0/0/1 or GigabitEthernet0/0/1. The configuration is as follows:

# Configuration the acl rule.

[HUAWEI] acl number 3333
[HUAWEI-acl-adv-3333] rule 5 permit icmp source 10.1.1.0 0.0.0.255
[HUAWEI-acl-adv-3333] quit
# Configuration the traffic classifier.

[HUAWEI] traffic classifier test
[HUAWEI-classifier-test] if-match acl 3333
[HUAWEI-classifier-test] quit
# Configuration the traffic behavior:
[HUAWEI] traffic behavior test
[HUAWEI-behavior-test] statistic enable
[HUAWEI-behavior-test] quit# Configuration the traffic policy.

[HUAWEI] traffic policy test
[HUAWEI-trafficpolicy-test] classifier test behavior test
[HUAWEI-trafficpolicy-test] quit# Apply the traffic policy:
# Apply the traffic policy test to the S2700 or S3700.
[HUAWEI] interface ethernet0/0/1
[HUAWEI-Ethernet0/0/1] traffic-policy test inbound# Apply the traffic policy test to the S5700.
[HUAWEI] interface gigabitethernet0/0/1
[HUAWEI-GigabitEthernet0/0/1] traffic-policy test inboundAfter the configuration, run the display traffic policy statistics interface interface-type interface-number command to view the traffic statistics. To re-collect traffic statistics, run the reset traffic policy statistics interface interface-type interface-number command to clear existing traffic statistics first.

NOTE:
The S2700 or S3700 can collect statistics only on incoming packets.
The S5700 can collect statistics on incoming and outgoing packets, but cannot collect statistics on packets sent from its own CPU.
hone
Cisco 2821
 
Posts: 177
Joined: Thu Jan 07, 2016 1:03 am

Advertisement


  • Advertisement


Similar topics


Return to Network Management

Who is online

Users browsing this forum: No registered users and 1 guest

cron